A few problems we had with this door - If you close the door too far it came off the track, if you open the door too far it came of the track, after a few trips the door wold come free during transit and swing outside its track damaging the door.
Below are the steps we took to correct the door and remove this pain point.
 |
| This was the only piece of hardware acting as a slide and or guide for the door. Within months started pulling out of the wall. |
 |
| This is the only door guide provided by factory. You can see the wear on the door with only one year of being built. |
 |
| This strap was designed to hold door in travel position. The snap pulled through often. |
 |
| I used wood and an aluminium angle to create a full length guide that was fastened with proper hardware to wall studs. This prevents the door from swinging while allowing it slide no matter the door position. I used a commercial door stop fastened to the wood after the aluminium angle.This stops the door from being opening too far. |
 |
I used a surface bolt fastened to the door with its keeper fastened to the wood before the aluminium angle.
For travel mode the door is opened until it stops, the surface bolt is put int its keeper. The keeps the door stationary between the rear stop and the bolt. It can not move during travel now.
During normal use mode the surface bolt is left out of it keeper and it acts a stop keeping the door from being opened too far while allowing it to be closed.
|
 |
| Door in travel mode |
 |
| I placed a table leg cap from Lowes that was the same width of the door as a stop to prevent the door from being opened too far. This is with door opened, you can still see the snap on the door from the factory keep that failed. |
 |
| This show the door closed against the stop. This modification has been a great improvement and removed this pain point for us. |
